nt led1 = 5; //Specify to which pin you are connecting the Left Oragne LED
int led2 = 7; //Specify to which pin you are connecting the Middle Oragne LED
int led3 = 9; //Specify to which pin you are connecting the Right Oragne LED
int led4 = 11; //Specify to which pin you are connecting the Red LED
// the setup routine runs once when you press reset:
void setup() {
// initialize the digital pin as an output.
pinMode(led1, OUTPUT);
pinMode(led2, OUTPUT);
pinMode(led3, OUTPUT);
pinMode(led4, OUTPUT);
}
// the loop routine runs over and over again forever:
void loop() {
//Light Status 1
digitalWrite(led4, HIGH); //turn the red LED on
digitalWrite(led1, HIGH); // turn the Left Orange LED on
delay(600); // wait for 600 milliseconds
digitalWrite(led1, LOW); // turn the Left Orange LED on off
delay(600); // wait for 600 milliseconds
//Light Status 2
{digitalWrite(led2, HIGH);
delay(600);
digitalWrite(led2, LOW);
delay(600);}
//Light Status 3
{digitalWrite(led3, HIGH);
delay(600);
digitalWrite(led3, LOW);
delay(600);}
//Light Status 4
{digitalWrite(led1, HIGH);
digitalWrite(led2, HIGH);
delay(600);
digitalWrite(led1, LOW);
digitalWrite(led2, LOW);
delay(600);}
//Light Status 5
{digitalWrite(led1, HIGH);
digitalWrite(led3, HIGH);
delay(600);
digitalWrite(led1, LOW);
digitalWrite(led3, LOW);
delay(600);}
//Light Status 6
{digitalWrite(led3, HIGH);
delay(600);
digitalWrite(led3, LOW);
delay(600);}
//Light Status 7
{digitalWrite(led1, HIGH);
delay(600);
digitalWrite(led1, LOW);
delay(600);}
//Light Status 8
{digitalWrite(led2, HIGH);
digitalWrite(led3, HIGH);
delay(600);
digitalWrite(led2, LOW);
digitalWrite(led3, LOW);
delay(600);}
//Light Status 9
{digitalWrite(led1, HIGH);
digitalWrite(led3, HIGH);
delay(600);
digitalWrite(led1, LOW);
digitalWrite(led3, LOW);
delay(600);}
}
Posté: Mer 08 Avr 2020 - 20:24
). Je lui ai imprimé un capuchon pour en faire une grenade. Et j'ai conçu et imprimé un greeblies qui me permet de la faire tenir à ma ceinture avec trois aimants :
?
.
